Panel Layout; Status Led - B2 Audio RAGE 1200.2 User Manual

Panel layout

INPUT OUT
L
R
INPUT
RCA signal input for left & right channel. (CH1 ~ CH4)
A minimum of 0.2V input signal is required for correct
operation.
output
RCA signal output to external devices, ampli ers, etc.
Gain
Adjusts signal input voltage from the input source to
match the ampli ers input stage. 0.2V ~ 5V is the operational Crossover selection switch, when placed in full, no crossover
voltage. Voltages beyond may cause errors or damages to
to the input section..
x10 (frequency multiplier)
When selected the High Pass crossovers frequency range is
multiplied by a factor of 10.
high inputs
High level input from loudspeaker wires, this option is only
preferred if there is no RCA connection available. This will
provide a signal input from the oem wire harness in the car.
rage 1200.2
HPF
GAIN HPF-FULL-LPF LPF
POWER
CLIP
x10
5V 0.2V
x1 40 500 PROTECT
20 1K
400 5K
CH.1 CH.2
CH.1&2
CH.3&4
CH.3 CH.4
Hpf (40 ~500 hz) High Pass crossover
41 click potentiometer with ACCU8 frequency tuning.
Each click corresponds to a selected frequency.
If the multiplier is used, the frequency on the clicks
increases by a factor of 10.
LPF (20 Hz ~ 1 Khz) Low pass crossover
41 click potentiometer with ACCU8 frequency tuning.
Each click corresponds to a selected frequency.
Hpf - full lpf
is applied. The frequency range of the ampli er is fullrange.

status led

Power lit = ampli er on, normal operation. Clip lit or ashing
= signal output to the speakers is not clean. Distortion is
detected. Protect = ampli er has shut down operation
Caused by error, user failure, thermal or damage.
4
rage 1200.4
GAIN HPF HPF-FULL-LPF
LPF
x10
5V 0.2V 40 500
x1 20 1K
400 5K
HPF
GAIN HPF-FULL-LPF LPF
x10
x1
5V 0.2V 40 500
20 1K
400 5K
POWER
CLIP
PROTECT
.