Related Manuals for B2 Audio RAGE 5000
Summary of Contents for B2 Audio RAGE 5000
- Page 1 IT can NEVER LOUD RagE 5000 USER MANUAL PRODUCT ID: R5K1222 www.b2audio.com - www.facebook.com/b2audio - instagram: @b2_audio...
-
Page 2: Table Of Contents
Don’t blow a fuse, keep calm. The next era comes with our rede ned levels. The Rage series is “The increased Desire for B2 audio”. The Rage should cover any need for near any type of user. Mono, 4ch or even mini size ampli cation, no problem, Rage covers it all. Enough power and authority re ned with the keystones of B2 audio will provide you with numerous hours of joy and sweetness. - Page 3 *full output power according to the spec is based on a sufficient electrical supply system. if your system is inadequate, the efficiency of the amplifier decreases hurting the performance! the RAGE 5000 will need a dedicated agm battery supply of min 350 ah and 6000 cca. If you are using a common lithium source of 6c, a 100 Ah lithium battery will suffice.
- Page 4 Panel layout speaker output input remote 40Hz 10KHz output input remote level control port Connection of external level controller with clipsensor RCA signal input from the source unit. Use a signal of min and voltmeter. Caution, it is not a volume knob and shall 0.2 V to max 5 V to ensure proper operation.
- Page 5 Power terminals REM out for external devices power terminal GND (Ground connection) +12v (Power connection) Connects to the vehicle’s chassis. Keep as short as Connects to the positivie terminal of the battery. possible (< 20” / 50 cm). Use minimum 0AWG cable For speci ed performance 0AWG cable is required.
-
Page 6: Installation
Installation Installation considerations If you choose to install the ampli er by yourself, please read the entire owner’s manual carefully. Before you start your installation, please take all steps into consideration. If in doubt, please go to www.b2audio.com for authorized distributors / dealers that will be able to con gure your set up &... -
Page 7: Speaker Connections
speaker connection speaker output input remote 40Hz 10KHz output Speaker impedance 1 Ohm ~ 8 Ohm will reach thermal at a faster rate & will eventually go into protect. Impedance load under 1 ohm is not warranted! We recommend using minumum 8 Ga speaker cables to acquire the intended performance & e ciency. Run the speaker cables from your speakers to the ampli er’s mounting location. -
Page 8: Troubleshooting
troubleshooting amplifier doesn’t turn on protection led is lit once the amplifier is turned on 9.5 V ~ 16 fuse blowing overheating audio output insufficient - distorted sound turn on thump high hiss - alternator whine...