Related Manuals for B2 Audio RAGE 1200.2
Summary of Contents for B2 Audio RAGE 1200.2
- Page 1 1200.2 rage 1200.4 USER MANUAL PRODUCT ID: rage12002df20 PRODUCT ID: rage12004df20...
- Page 2 Don’t blow a fuse, keep calm. The next era comes with our rede ned levels. The Rage series is “The increased Desire for B2 audio”. The Rage should cover any need for near any type of user. Mono, 4ch or even 6 ch ampli cation, no problem, Rage embodies it all. Enough power and authority re ned with the keystones of B2 audio will provide you with numerous hours of joy and sweetness.
-
Page 3: Design Features
Design features rage 1200.2 rage 1200.4 Circuit Configuration: Hi-ef class d fullrange Hi-ef class d fullrange Frequency Response: 10 Hz ~ 25 KHz (+/- 2 db) 10 Hz ~ 25 KHz (+/- 2 db) Signal to Noise Ratio: > 90 dB >... -
Page 4: Panel Layout
Panel layout rage 1200.2 rage 1200.4 CH.1 CH.2 INPUT GAIN HPF-FULL-LPF GAIN HPF-FULL-LPF POWER POWER CLIP CLIP CH.1&2 0.2V PROTECT 0.2V PROTECT CH.3&4 GAIN HPF-FULL-LPF 0.2V CH.3 CH.4 INPUT Hpf (40 ~500 hz) High Pass crossover RCA signal input for left & right channel. (CH1 ~ CH4) 41 click potentiometer with ACCU8 frequency tuning. -
Page 5: Power Terminal
Power terminals rage 1200.2 rage 1200.4 +12 V +12 V + 3CH L-CH R-CH BRIDGED - 3CH BRIDGED BRIDGED 100 A fuse rating 100 A fuse rating power terminal GND (Ground connection) +12v (Power connection) Connects to the vehicle’s chassis. Keep as short as Connects to the positivie terminal of the battery. - Page 6 Installation Installation considerations If you choose to install the ampli er by yourself, please read the entire owner’s manual carefully. Before you start your installation, please take all steps into consideration. If in doubt, please go to www.b2audio.com for authorized distributors / dealers that will be able to con gure your set up &...
-
Page 7: Speaker Connection
1200.2 rage 1200.4 +12 V +12 V + 3CH L-CH R-CH BRIDGED - 3CH BRIDGED BRIDGED Speaker impedance 2 Ohm ~ 8 Ohm will reach thermal at a faster rate & will eventually go into protect. Impedance load under 2 ohm is not warranted! We recommend using minumum10 Ga speaker cables to acquire the intended performance &... - Page 8 1200.2 rage 1200.4 CH.1 CH.2 INPUT GAIN HPF-FULL-LPF GAIN HPF-FULL-LPF POWER POWER CLIP CLIP CH.1&2 0.2V PROTECT 0.2V PROTECT CH.3&4 GAIN HPF-FULL-LPF 0.2V CH.3 CH.4 The low pass crossover & high pass crossover are 24 dB / oct. Setting it at 80 Hz will then have the signal cut off with 24 dB at 40 Hz (1 octave).
- Page 9 17.5 V.