Introduction We thank you for purchasing our amplifiers. Your decision to be part of something different is what we strive for. Our products reflects who we are, going to the extent to deliver you our finest comes natural. to upgrade the stock electrical system. Ensure the system is in accordance with the full performance of the amplifier. www.facebook.com/sweetlikedanish - www.youtube.com/b2audio - www.b2audio.com - www.twitter.com/b2_audio - wwww.instagram.com/b2_audio Better Bass Better Bass is our philosophy of adding something extra.
400 w x 1 Power @ 1 Ω: 600 w x 1 Description of specifications Stable impedance load of the SLD600 is 1 Ohm. * Speaker overload * Short circuit * Input Voltage - RCA & Power Supply Operational voltage: 10 V ~ 15.5 V. Operational voltage will also be affected by the load of the amplifier...
Panel layout SLD600 INPUT BASS BOOST RCA signal input for Left & Right channel. Variable signal boost of the BASS FREQ chosen A minimum of 0.2 v input signal is required for correct with 0 dB ~ 15 dB. operation.
Page 5
Panel layout Head unit sld600 GROUND* * Keep ground as short as possible, no longer than 20” (50 cm). 60A (External fuse) BATTERY GND (GROUND CONNECTION) + 12V (POWER CONNECTION) Connects to the vehicle’s chassis. Connects to the positive terminal of the battery.
Installation Installation considerations If you choose to install the ampli er by yourself, please read the entire owner’s manual carefully. Before you start your installation, please take all steps into consideration. If in doubt, please go to www.b2audio.com for authorized distributors / dealers that will be able to con gure your set up &...
Head unit sld600 GROUND* * Keep ground as short as possible, no longer than 20” (50 cm). 60A (External fuse) BATTERY Speaker impedance 1 Ohm ~ 8 Ohm Loads under what is speci ed will cause excessive heat & the ampli er will reach thermal at a faster rate &...
Troubleshooting The protection circuits of the ampli er prevents severe damages from faulty conditions & improper use. The protection indicatior will switch on due to short circuit connection & speaker overload, thus the ampli er will be turned o . Prior to inspecting the occurred problem, turn all levels down &...
Page 9
Items not installed by authorized dealers will be warrantied for 30 days from the original purchase. Original sales receips must be accompanied with all returns.The warranty applies to the original purchaser of the product & it being sold by authorized B2 audio dealers.