Using Prophet-5'S Gate In And Gate Out - Sequential prophet 5 User Manual

6. Send a "C" from the controlling device, corresponding in pitch to the
low C note on the Prophet-5's keyboard.
7. Use the
switches to make negative or positive adjustments to the CV In Low
Point, bringing the Prophet-5's pitch to "C". The Prophet-5's CV Input
is quantized to semitones, so the pitch will jump abruptly as you make
the adjustment, rather than change gradually.
8. Press
program select
9. Repeat steps 5-7. The target pitch for the CV Out High Point is "C"
five octaves above the Low Point pitch.
10. Press
program select

Using Prophet-5's Gate In and Gate Out

The Prophet-5 can interface with a gear that accepts gate in or gate out
signals for envelope triggering.
Note that Prophet-5 Gate Out signals are output from the Prophet-5
keyboard each time a key is pressed. Note also that when a jack is
inserted into the Prophet-5's rear-panel
available to play from the keyboard and will instead be triggered by the
external gate signal.
The Prophet-5's
voltage above 1.7v will gate its envelopes.
To use the Prophet-5's Gate Out:
1. Using a ¼ inch patch cable, connect the Prophet-5's Gate Out to the
appropriate Gate In on the external device
2. Play the Prophet-5 keyboard. The external device should respond to the
Prophet-5 envelope triggers each time you strike a key.
To use the Prophet-5's Gate In:
1. Using a ¼ inch patch cable, connect the Prophet-5's Gate In to the
appropriate Gate Out on the external device.
2. Play the external device. The Prophet-5 should respond to the Gate
signal of the external device. As noted above, voice 5 is no longer
available to play from the keyboard and will instead be triggered by the
external gate signal.
Prophet-5 User's Guide
(decrement) and
group select
button 4 to begin adjusting the CV In High Point.
button 8 to exit CV Calibration Mode.
is tolerant of voltages up to 15v, but any positive
gate in
bank select
jack, voice 5 is no longer
gate in
Chapter 4: Using CVs and Gates
(increment)
55