Telnet; Figure 137 Telnet Configuration On A Tcp/Ip Network; Table 98 Remote Management: Www - ZyXEL Communications 802.11g HomePlug AV ADSL2+ Gateway P-660HWP-Dx User Manual

The following table describes the labels in this screen.

Table 98 Remote Management: WWW

LABEL
Port
Access Status
Secured Client IP A secured client is a "trusted" computer that is allowed to communicate with the P-
HTTPS
Server Host Key
Authenticate
Client Certificates
Port
Access Status
Secured Client IP A secured client is a "trusted" computer that is allowed to communicate with the P-
Apply
Cancel

17.3 Telnet

You can configure your P-660HWP-Dx for remote Telnet access as shown next. The
administrator uses Telnet from a computer on a remote network to access the P-660HWP-Dx.

Figure 137 Telnet Configuration on a TCP/IP Network

P-660HWP-Dx User's Guide
DESCRIPTION
You may change the server port number for a service if needed, however you must
use the same port number in order to use that service for remote management.
Select the interface(s) through which a computer may access the P-660HWP-Dx
using this service.
660HWP-Dx using this service.
Select All to allow any computer to access the P-660HWP-Dx using this service.
Choose Selected to just allow the computer with the IP address that you specify to
access the P-660HWP-Dx using this service.
Select the Server Certificate that the P-660HWP-Dx will use to identify itself. The
P-660HWP-Dx is the SSL server and must always authenticate itself to the SSL
client (the computer which requests the HTTPS connection with the P-660HWP-
Dx).
Select Authenticate Client Certificates (optional) to require the SSL client to
authenticate itself to the P-660HWP-Dx by sending the P-660HWP-Dx a certificate.
To do that the SSL client must have a CA-signed certificate from a CA that has
been imported as a trusted CA on the P-660HWP-Dx.
You may change the server port number for a service if needed, however you must
use the same port number in order to use that service for remote management.
Select the interface(s) through which a computer may access the P-660HWP-Dx
using this service.
660HWP-Dx using this service.
Select All to allow any computer to access the P-660HWP-Dx using this service.
Choose Selected to just allow the computer with the IP address that you specify to
access the P-660HWP-Dx using this service.
Click Apply to save your settings to the P-660HWP-Dx.
Click Cancel to begin configuring this screen afresh.
Chapter 17 Remote Management Configuration
37