Appendix F Command Interpreter; Accessing The Cli; Command Syntax; Command Usage - ZyXEL Communications 802.11g HomePlug AV ADSL2+ Gateway P-660HWP-Dx User Manual

A
P P E N D I X
The following describes how to use the command interpreter. You can telnet to access the CLI
(Command Line Interface) on the P-660HWP-Dx. See the included disk or zyxel.com for
more detailed information on these commands.
Use of undocumented commands or misconfiguration can damage the unit and
possibly render it unusable.

Accessing the CLI

Use the following steps to telnet into your P-660HWP-Dx.
1 Connect your computer to the ETHERNET port on the P-660HWP-Dx.
2 Make sure your computer IP address and the P-660HWP-Dx IP address are on the same
subnet. In Windows, click Start (usually in the bottom left corner), Run and then type
telnet 192.168.1.1
3 A login screen displays. Enter the default admin password "1234".

Command Syntax

• The command keywords are in courier new font.
• Enter the command keywords exactly as shown, do not abbreviate.
• The required fields in a command are enclosed in angle brackets <>.
• The optional fields in a command are enclosed in square brackets [].
• The |symbol means or.
For example,
sys filter netbios config <type> <on|off>
means that you must specify the type of netbios filter and whether to turn it on or off.

Command Usage

A list of valid commands can be found by typing help or? at the command prompt. Always
type the full command. Type exit to log out of the CLI when finished.
P-660HWP-Dx User's Guide
Command Interpreter
(the default P-660HWP-Dx IP address) and click OK.
F
35