Ssid; The Ssid Screen - ZyXEL Communications ZyXEL NWA3160 User Manual

Chapter 10 MBSSID and SSID
Table 48 Wireless: Multiple BSS
LABEL
Profile
Enable Spanning Tree
Control (STP)
Roaming Active
Apply
Reset

10.2 SSID

When the ZyXEL Device is set to Access Point, AP+Bridge (NWA-3160 and NWA-3163
only) or MBSSID mode, you need to choose the SSID profile(s) you want to use in your
wireless network (see
Use the WIRELESS > SSID screen to see information about the SSID profiles on the ZyXEL
Device, and use the WIRELESS > SSID > Edit screen to configure the SSID profiles.

10.2.1 The SSID Screen

Click WIRELESS > SSID to display the screen as shown.
140
DESCRIPTION
Select the profile(s) of the SSIDs you want to use in your wireless network.
You can have up to eight BSSs running on the ZyXEL Device simultaneously,
one of which is always the pre-configured VoIP_SSID profile and another of
which is always the pre-configured Guest_SSID profile.
Configure SSID profiles in the SSID screen.
(R)STP detects and breaks network loops and provides backup links between
switches, bridges or routers. It allows a bridge to interact with other (R)STP -
compliant bridges in your network to ensure that only one path exists between
any two stations on the network. Select the check box to activate STP on the
ZyXEL Device.
Roaming allows wireless stations to switch from one access point to another
as they move from one coverage area to another. Select this checkbox to
enable roaming on the ZyXEL Device if you have two or more ZyXEL Devices
on the same subnet.
Note: All APs on the same subnet and the wireless stations
must have the same SSID to allow roaming.
Click Apply to save your changes.
Click Reset to begin configuring this screen afresh.
Section 8.6 on page 110 for more information on operating modes).
ZyXEL NWA-3160 Series User's Guide