Log Commands; Configuring What You Want The Zyxel Device To Log; Displaying Logs; Table 82 Sys Log - ZyXEL Communications ZyXEL NWA3160 User Manual

Chapter 17 Log Screens
Table 81 ICMP Notes (continued)
TYPE
16

Table 82 Sys log

LOG MESSAGE
Mon dd hr:mm:ss hostname
src="<srcIP:srcPort>"
dst="<dstIP:dstPort>"
msg="<msg>" note="<note>"

17.4 Log Commands

Go to the command interpreter interface (the Command Interpreter appendix explains how to access and
use the commands).

17.4.1 Configuring What You Want the ZyXEL Device to Log

Use the sys logs load command to load the log setting buffer that allows you to configure which logs
the ZyXEL Device is to record.
Use sys logs category followed by a log category and a parameter to decide what to record

Table 83 Log Categories and Available Settings

LOG CATEGORIES
error
mten
Use 0 to not record logs for that category,
alerts for that category, and
Use the sys logs save command to store the settings in the ZyXEL Device (you must do this in order
to record logs).

17.4.2 Displaying Logs

Use the sys logs display command to show all of the logs in the ZyXEL Device's log.
Use the sys logs category display command to show the log settings for all of the log categories.
Use the sys logs display [log category] command to show the logs in an individual ZyXEL
Device log category.
Use the sys logs clear command to erase all of the ZyXEL Device's logs.
204
CODE DESCRIPTION
Information Reply
Information reply message
0
3
to record both logs and alerts for that category.
DESCRIPTION
This message is sent by the "RAS" when this syslog is
generated. The messages and notes are defined in this
appendix's other charts.
AVAILABLE PARAMETERS
0, 1, 2, 3
0, 1
1 to record only logs for that category,
ZyXEL NWA-3160 Series User's Guide
2 to record only