Access Point Mode: Nwa-3165; Figure 65 Wireless: Access Point (Nwa-3165); Table 36 Wireless: Access Point (Nwa-3165) - ZyXEL Communications ZyXEL NWA3160 User Manual

Chapter 8 Wireless Configuration
Table 35 Wireless: Access Point (NWA-3160 and NWA-3163)
LABEL
Enable Antenna
Diversity
Enable
Spanning Tree
Protocol (STP)
Enable
Roaming
Apply
Reset

8.7.2 Access Point Mode: NWA-3165

This section describes the Access Point mode screen for the NWA-3165. For the NWA-3160
and NWA-3163, see
Select Access Point as the Operating Mode to display the screen shown next.

Figure 65 Wireless: Access Point (NWA-3165)

The following table describes the general wireless LAN labels in this screen.

Table 36 Wireless: Access Point (NWA-3165)

LABEL
Operating Mode Select Access Point from the drop-down list.
802.11 Mode
114
DESCRIPTION
Select this to use antenna diversity. Antenna diversity uses multiple antennas to
reduce signal interference.
(R)STP detects and breaks network loops and provides backup links between
switches, bridges or routers. It allows a bridge to interact with other (R)STP -
compliant bridges in your network to ensure that only one path exists between any
two stations on the network. Select this to activate STP on the ZyXEL Device.
Roaming allows wireless stations to switch from one access point to another as
they move from one coverage area to another. Select this to enable roaming on the
ZyXEL Device if you have two or more ZyXEL Devices on the same subnet.
Note: All APs on the same subnet and the wireless stations
must have the same SSID to allow roaming.
Click Apply to save your changes.
Click Reset to begin configuring this screen afresh.
Section 8.7.1 on page
DESCRIPTION
Select 802.11b/g to allow both IEEE802.11b and IEEE802.11g compliant WLAN
devices to associate with the ZyXEL Device. The transmission rate of your ZyXEL
Device might be reduced.
Select 802.11n/g to allow both IEEE802.11n and IEEE802.11g compliant WLAN
devices to associate with the ZyXEL Device.
111.
ZyXEL NWA-3160 Series User's Guide