ZyXEL Communications ZyXEL NWA3160 User Manual page 119

Table 37 Wireless: Bridge/Repeater (NWA-3160 and NWA-3163 Only)
LABEL
Output Power
Enable WDS Security Select this to turn on security for the ZyXEL Device's Wireless Distribution
TKIP (ZyAIR Series
Compatible)
AES
#
Active
Remote Bridge MAC
Address
PSK
See Table 35 on page 112
ZyXEL NWA-3160 Series User's Guide
DESCRIPTIONS
Set the output power of the ZyXEL Device in this field. If there is a high density
of APs in an area, decrease the output power of the ZyXEL Device to reduce
interference with other APs. Select from 100% (Full Power), 50%, 25%, 12.5%
and Minimum. See the product specifications for more information on your
ZyXEL Device's output power.
System (WDS). A Wireless Distribution System is a wireless connection
between two or more APs. If you do not select the check box, traffic between
APs is not encrypted.
Note: WDS security is independent of the security settings
between the ZyXEL Device and any wireless clients.
When you enable WDS security, also do the following:
• Select the type of security you want to use (TKIP or AES) to secure traffic
on your WDS.
• Enter a pre-shared key in the PSK field for each access point in your WDS.
Each access point can use a different pre-shared key.
• Configure WDS security and the relevant PSK in each of your other access
point(s).
Note: Other APs must use the same encryption method to
enable WDS security.
Select this to enable Temporal Key Integrity Protocol (TKIP) security on your
WDS. This option is compatible with other ZyXEL access points including that
support WDS security. Use this if the other access points on your network
support WDS security but do not have an AES option.
Note: Check your other AP's documentation to make sure it
supports WDS security.
Note: At the time of writing, this option is compatible with
other ZyXEL NWA Series and G-3000/G-3000H access
points only.
Select this to enable Advanced Encryption System (AES) security on your
WDS. AES provides superior security to TKIP. Use AES if the other access
points on your network support it for the WDS.
Note: At the time of writing, this option is compatible with
other ZyXEL NWA-3160 access points only.
This is the index number of the bridge connection.
Select the check box to enable the bridge connection. Otherwise, clear the
check box to disable it.
Type the MAC address of the peer device in a valid MAC address format, that
is, six hexadecimal character pairs, for example, 12:34:56:78:9a:bc.
Type a pre-shared key (PSK) from 8 to 63 case-sensitive ASCII characters
(including spaces and symbols). You must also set the peer device to use the
same pre-shared key. Each peer device can use a different pre-shared key.
for information on the other labels in this screen.
Chapter 8 Wireless Configuration
119