Step 4 Ssid - ZyXEL Communications NWA90AX User Manual

7.2.4 Step 4 SSID

Use this screen to enable, disable or edit an SSID profile.
Select an SSID profile and click the Status switch to turn it on or off. To change an SSID profile's settings,
such as the SSID (WiFi network name) and WiFi password, double-click the SSID profile entry from the list.
See Section 7.2.4.1 on page 54
Note: You cannot add or remove an SSID profile after running the setup wizard.
Figure 33 Wizard: SSID
7.2.4.1 Edit SSID Profile
Use this screen to configure an SSID profile.
The screen varies depending on the security type you selected.
• SSID: Enter a descriptive name of up to 32 printable characters for the wireless LAN.
• VLAN ID: Enter a VLAN ID for the Zyxel Device to use to tag traffic originating from this SSID.
Band Mode: Select the wireless band which this profile should use. 2.4 GHz is the frequency used by
IEEE 802.11b/g/n wireless clients. 5 GHz is the frequency used by IEEE 802.11ac/a/n wireless clients.
• Security Type: Select WPA2 to add security on this wireless network. Otherwise, select OPEN to allow
any wireless client to associate this network without authentication.
• Personal: If you set Security Type to WPA2 and select Personal, enter a pre-shared key of between 8
and 63 case-sensitive ASCII characters (including spaces and symbols) or 64 hexadecimal
characters.
Note: For Zyxel Device models that support enterprise security mode:
You can select the Enterprise mode in Configuration > Object > AP Profile > SSID >
Security List > Edit.
Click OK to proceed. Click Cancel to close the screen without saving.
Chapter 7 Setup Wizard
for more information.
NWA50AX/NWA90AX/NWA55AXE Series User's Guide
54