dehn DEHNcare APS Series User Information page 13

Face shield with CLIP
The APS...SC face shield is positioned above the safety helmet and both clips are snapped into the slots on the helmet. Check that
they are secure (see Figure 1).
Note concerning the replacement of the visor holder:
The visor holder can be replaced if necessary or if it is damaged (see accessories, Table 2, page 6). To do so, the visor holder and visor
should be carefully removed from the safety helmet.
Remove the visor holder from the visor as follows:
Â
APS... type: Turn the fi ve locking noses so that they fi t through the relevant slots in the visor. Then remove the visor from the visor
holder.
For both types, the visor is inserted in the new visor holder following this procedure in reverse order.
Important: Do not remove the chin protector of the visor. This is a permanent fi xture!
APS... SC face shield
APS T...SC face shield
integrated locking mechanism
Figure 1 Face shield with CLIP
clip
locking screw
locking nose
slot
locking screw
clip
Important:
Completely snap both clips
into the slot of the helmet
and make sure they are
secure!
5