Parts Counting - KERN GAB-N Series Operating Instructions Manual

10.4 Parts counting

Before the balance can count parts, it must know the average part weight (i.e.
reference). Proceed by putting on a certain number of the parts to be counted. The
balance determines the total weight and divides it by the number of parts (the so-
called reference quantity). Counting is then carried out on the basis of the calculated
average piece weight.
The higher the reference quantity the higher the counting exactness.
 Place the reference quantity
(example)
 Press
 Reference quantities of 10, 20, 50, 100 and 200 can be set
 Confirm by pressing
(example)

----
GROSS

10 pcs
GROSS
 To change between reference weight, total weight and
 To return to weighing mode, press the
GAB-N-BA-e-1817
F
, the scales will change to quantity counting mode
C
Reference quantity of 10, P 10 will appear.
TARE
by pressing .
You will briefly see a line on the screen before the scales
show the respective quantity
quantity, press the
0
key.
F
C
key.
25