Table of Contents
Advertisement
Prestige 623ME-T User's Guide
18.3.2 Generic Filter Rule
This section shows you how to configure a generic filter rule. The purpose of generic rules is to allow you
to filter non-IP packets. For IP, it is generally easier to use the IP rules directly.
For generic rules, the Prestige treats a packet as a byte stream as opposed to an IP packet. You specify the
portion of the packet to check with the Offset (from 0) and the Length fields, both in bytes. The Prestige
applies the Mask (bit-wise ANDing) to the data portion before comparing the result against the Value to
determine a match. The Mask and Value fields are specified in hexadecimal numbers. Note that it takes
two hexadecimal digits to represent a byte, so if the length is 4, the value in either field will take 8 digits,
for example, FFFFFFFF.
To configure a generic rule select an empty filter set in menu 21, for example 6. Select Generic Filter
Rule in the Filter Type field and press [ENTER] to open Menu 21.6.1
the following figure.
Press Space Bar to Toggle.
The next table describes the fields in the Generic Filter Rule menu.
FIELD
Filter #
This is the filter set, filter rule coordinates, for instance, 2, 3 refers to the
second filter set and the third rule of that set.
18-12
Menu 21.6.1 - Generic Filter Rule
Filter #: 6,1
Filter Type= Generic Filter Rule
Active= No
Offset= 0
Length= 0
Mask= N/A
Value= N/A
More= No
Action Matched= Check Next Rule
Action Not Matched= Check Next Rule
Press ENTER to Confirm or ESC to Cancel:
Figure 18-9 Menu 21.6.1 Generic Filter Rule
Table 18-4 Menu 21.6.1 Generic Filter Rule
DESCRIPTION
Generic Filter Rule, as shown in
–
Log= None
EXAMPLE
6,1
Filter Configuration
Advertisement
Table of Contents
