Table of Contents
Advertisement
17.3 NAT Server Setup
A server set is a list of LAN servers mapped to external ports. To use this set, NAT must be enabled. Please
see the section on port forwarding in the chapter on NAT web configurator screens for further information
on these menus. To configure NAT Server Setup, enter 15 from the main menu to bring up the following
screen.
Step 1.
Enter a port number in an unused Start Port No field. To forward only one port, enter it again
in the End Port No field. To specify a range of ports, enter the last port to be forwarded in the
End Port No field.
Step 2.
Enter the inside IP address of the server in the IP Address field. In the following figure, you
have a computer acting as an FTP, Telnet and SMTP server (ports 21, 23 and 25) at
192.168.1.33.
Step 3.
Press [ENTER] at the "Press ENTER to confirm ..." prompt to save your configuration after
you define all the servers or press [ESC] at any time to cancel.
17.4 General NAT Examples
The following are some examples of NAT configuration using the SMT.
17.4.1 Example 1: Internet Access
In the following Internet access example, one public IP address on the WAN is mapped to several private IP
addresses on the LAN. Therefore these LAN computers are invisible to the outside world.
NAT
Menu 15.2.1 - NAT Server Setup
Rule
Start Port No.
---------------------------------------------------
1.
Default
2.
21
3.
0
4.
0
5.
0
6.
0
7.
0
8.
0
9.
0
10.
0
11.
0
12.
0
Press ENTER to Confirm or ESC to Cancel:
Figure 17-3 Menu 15.2.1 NAT Server Setup
Prestige 623ME-T User's Guide
End Port No.
IP Address
Default
0.0.0.0
25
192.168.1.33
0
0.0.0.0
0
0.0.0.0
0
0.0.0.0
0
0.0.0.0
0
0.0.0.0
0
0.0.0.0
0
0.0.0.0
0
0.0.0.0
0
0.0.0.0
0
0.0.0.0
17-3
Advertisement
Table of Contents
