Table of Contents
Advertisement
Prestige 623ME-T User's Guide
Press Space Bar to Toggle.
The following table describes how to configure your TCP/IP filter rule.
FIELD
Filter #
Filter Type
Active
IP Protocol
IP Source Route
Destination:
IP Addr
18-8
Menu 21.6.1 - TCP/IP Filter Rule
Filter #: 6,1
Filter Type= TCP/IP Filter Rule
Active= No
IP Protocol= 0
Destination: IP Addr=
Source: IP Addr=
TCP Estab= N/A
More= No
Action Matched= Check Next Rule
Action Not Matched= Check Next Rule
Press ENTER to Confirm or ESC to Cancel:
Figure 18-7 Menu 21.x.1 TCP/IP Filter Rule
Table 18-3 Menu 21.x.1 TCP/IP Filter Rule
This is the filter set, filter rule coordinates, for instance, 2, 3 refers
to the second filter set and the third filter rule of that set.
Use [SPACE BAR] and then [ENTER] to choose a rule.
Parameters displayed for each type will be different. Choices are
TCP/IP Filter Rule or Generic Filter Rule.
Select Yes to activate or No to deactivate the filter rule.
This is the upper layer protocol, for example, TCP is 6, UDP is 17
and ICMP is 1. The value must be between 0 and 255. A value of
O matches ANY protocol.
IP Source Route is an optional header that dictates the route an
IP packet takes from its source to its destination. If Yes, the rule
applies to any packet with an IP source route. The majority of IP
packets do not have source route.
Type the destination IP address of the packet you want to filter.
This field is ignored if it is 0.0.0.0.
IP Source Route= No
IP Mask=
Port #=
Port # Comp= None
IP Mask=
Port #=
Port # Comp= None
Log= None
DESCRIPTION
EXAMPLE
6,1
TCP/IP Filter
Rule
No
(default)
0 to 255
No
(default)
IP address
Filter Configuration
Advertisement
Table of Contents
