Advertisement
9.5 Vibration Strength (without packing)
There shall be no sign of malfunction after the following vibration test.
Vibration test: Increase the frequency of the vibration from 10Hz to 100Hz at an accelerated velocity
2
of 19.6m/s
(2.0 G) for 30 minutes (60 minutes per cycle) in the non-operating state. Repeat this in
each X, Y and Z direction.
9.6 Vibration Strength (in individual packing)
There shall be no sign of malfunction after the following vibration test.
Vibration test: Increase the frequency of the vibration from 10Hz to 100Hz at an accelerated velocity
2
of 19.6 m/s
(2.0 G) for 30 minutes (60 minutes per cycle) in individually packaged state. Repeat this
in each X, Y and Z direction.
9.7 Drop Impact Strength (without packaging)
There shall be no sign of malfunction after the following drop test.
Drop test: Drop the scanner 18 times in total (3 times at each 6 face), from a height of 75 cm onto a
concrete floor as shown below.
9.8 Drop Impact Strength (in individual packaging)
There shall be no sign of malfunction after the following drop test.
Drop test: Drop an individually packaged scanner 10 times in total, at any of 1 corner, 3 edges, and 6
faces, from a height of 100 cm onto a concrete floor.
9.9 Dust and Drip Proof
IP65
Dust Prevention
Level
6
No ingress of dust; complete protection against contact
Water Prevention
Level
5
Water projected by a nozzle (6.3mm) against enclosure from any direction shall have no harmful effects.
SPECIFICATIONS MANUAL
Figure 12: Drop Test
Details
Details
NLV-4001
2nd
15
Advertisement
