Advertisement
2.1.3.2. Dealer Mode – DTMF Settings
To place the unit into the "Dealer Mode" for editing the DTMF settings, do the following:
1. While pressing and holding the [LAMP] and [DIAL] buttons, switch the power "on". After
2 seconds the radio enters the dealer mode and "SEL" appears on the display.
2. While in dealer mode, press [DIAL] to enter the DTMF Settings mode.
Table 2.3 shows the function number and function options that can be selected while in this
mode. While in this mode, the Channel Selector knob and keypad (0-9, *, #, A-D) are used to
set DTMF functions "ON" or "OFF" or to select the setting. After a function is set, pressing the
1
[PTT]
button stores the setting and increments the menu to the next function option. Also, when
the [PTT] button is pushed, a beep will sound to confirm the setting.
Pressing the [SCN] button at any time while reviewing the function options will cause the unit to
exit the selection mode and revert back to the dealer mode screen. The current function option
will not be stored if it was changed. After the complete option list has been cycled through,
"End" will appear on the display. To exit dealer mode, cycle the power "off" and then back "on".
To review or confirm the function settings while in the DTMF Settings mode, press and hold the
[MONI] button and turn the channel select knob.
Function
Function
No.
Name
24
DIGIT TIME
INTER DIGIT
25
TIME
FIRST DIGIT
26
TIME
27
RISE TIME
RISE TIME
28
WITH CTCSS
1
Except for functions 31 and 32, which are set with the keypad.
2
When DTMF function is enabled together with the Battery Save mode, and when CTCSS is used, the
transmit delay time should be set > 300 ms.
RELM Communications
Option
(Defaults are
highlighted)
50ms ~ 200ms
(10ms steps)
50ms ~ 200ms
(10ms steps)
50ms ~ 200ms
(10ms steps)
100ms~1000ms
2
(50ms steps)
100ms~1000ms
(50ms steps)
2
Display
Left Right
Char. Char.
24
50
The period of time that each of the
programmed DTMF ANI digits are
transmitted.
24 200
25
50
The period of time between each of the
programmed DTMF ANI digits
25 200
26 50
The period of time that the first digit of
the programmed DTMF ANI is
transmitted.
26 200
27 100
The period of time between un-
modulated TX carrier and when the
programmed DTMF ANI is transmitted.
27 1000
28 100
The period of time between un-
modulated TX carrier and when the
28 1000
programmed CTCSS is transmitted.
Remarks
Page 13
Advertisement
