Advertisement
will not be stored if it was changed. After the complete option list has been cycled through,
"End" will appear on the display. To exit dealer mode, cycle the power "off" and then back "on".
To review or confirm the function settings while in the Enhanced Global Set mode, press and
hold the [MONI] button and turn the channel select knob.
Function
Function
No.
Name
43
A TONE
DURATION
44
B TONE
DURATION
45
GAP TIME
46
AUTO
RESET
TIME
47
Key 1,
Key2, Key3,
Key 4
Assignment
48
Key 5 & Key
6
Assignment
Table 2.5 - Dealer Mode Enhanced Global Settings
2.1.3.4. Dealer Mode - Channel Settings
To place the unit into the "Dealer Mode" for editing the channel settings, do the following:
1. While pressing and holding the [LAMP] and [DIAL] buttons, switch the power "on". After
2 seconds the radio enters the dealer mode and "SEL" appears on the display.
2. While in dealer mode, press [TA] to enter the Channel Setting mode.
Table 2.6 shows the function number and function options that can be selected while in this
mode. While in this mode, the Channel Selector knob is used to set functions "ON" or "OFF" or
to select the setting. After a function is set, pressing the [PTT] button stores the setting and
increments the menu to the next function option. Also, when the [PTT] button is pushed, a beep
will sound to confirm the setting.
Pressing the [TA] button at any time while reviewing the function options will cause the unit to
exit the selection mode and revert back to the dealer mode screen. The current function option
Page 18
Option
(Defaults are
highlighted)
0.5~10s
(0.1s steps)
0.5~10s
(0.1s steps)
0~10s
(0.1s steps)
OFF, 1~60s
(1s steps)
There are 24 arrays
There are 2 arrays
Display
Left Right
Char. Char.
43 0.5
A Tone transmit time.
Default =
0.5
44 0.5
B Tone transmit time.
Default =
0.5
45 0.5
Period of time of un-modulated carrier
Default =
between A tone and B tone.
0.5
46 OFF
Disabled
46 5
The time allowed for the receiving unit to
respond back to the sender before the unit
resets back to signal decoding mode.
47 1234
The SCN (Scan), DIAL (DTMF Dial), TA (Talk
Around), and LO (Low Power) keys can be
assigned to 24 predetermined configurations.
47 1324
.
47 4321
48 56
The Mon (Monitor) and LAMP keys can be
assigned to 2 predetermined configurations.
48 65
Remark
RELM Communications
Advertisement
