Advertisement
will not be stored if it was changed. After the complete option list has been cycled through,
"End" will appear on the display. To exit dealer mode, cycle the power "off" and then back "on".
Function
Option
Name
(Defaults are
highlighted)
CHANNEL
1CH ~ 99CH
SELECT
RX
Blank
FREQUENCY
RX TONE
Disable
CTCSS
67.0 Hz – 250.3Hz
CDCSS
TX
Blank
FREQUENCY
RELM Communications
Display
Left Right
Char. Char.
CH 1
Channel to be programmed.
CH 99
_ _ - - - - - _
No receive or transmit frequency
0.0000
15
0
Pressing the [LO] button toggles no frequency to the start
of the receive frequency if the channel is blank.
0.0025
15
0
Rotating the channel selector will raise or lower the
frequency by 2.5KHz increments.
0.1000
15
0
Pressing the [SCN] key will cause the 2nd, 3rd, and 4th
digits past the decimal point to change to zeros.
0.0625
15
0
Holding in the [SCN] key and rotating the channel selector
will raise or lower the frequency by 6.25KHz increments.
1.0000
15
0
Holding in the lamp key and rotating the channel selector
will raise or lower the frequency by 1MHz increments.
OFF
Disables CTCSS or DCS
67.0
Selecting the [LO] key switches it from OFF to the first
CTCSS tone. Rotate the channel selector to move the
tone frequency up or down until the desired tone
frequency is reached.
023
Selecting the [LO] key again switches it from CTCSS to
the first DCS tone. Rotate the channel selector to move
the DCS code up or down until the desired code is
reached.
_ _ - - - - - _
No transmit frequency. Receive only.
0.0000
15
0
Pressing the [LO] button toggles no frequency to the start
of the transmit frequency if the channel is blank.
0.0025
15
0
Rotating the channel selector will raise or lower the
frequency by 2.5KHz increments.
0.1000
15
0
Pressing the [SCN] key will cause the 2nd, 3rd, and 4th
digits past the decimal point to change to zeros.
0.0625
15
0
Holding in the [SCN] key and rotating the channel selector
will raise or lower the frequency by 6.25KHz increments.
1.0000
15
0
Holding in the lamp key and rotating the channel selector
will raise or lower the frequency by 1MHz increments.
Remark
Page 19
Advertisement
