Advertisement
Do the following with the master radio:
4. While pressing and holding the [LAMP] and [DIAL]
buttons, switch the power "on". After 2 seconds the
radio enters the dealer mode and "SEL" appears on
the display.
5. Press the [MONI] button to enter the wireless clone
mode. A frequency will appear in the display. Adjust
the channel select knob to adjust the frequency to
the desired frequency to transmit data on. Note:
Pressing the [LAMP] button while turning the
channel selector, will change the frequency in 1
MHZ steps.
6. Press the PTT button to start cloning. "ooCL0nE"
will appear in the displays of both the master and
slave units. Also, the "Lo" power icon will be
displayed on the mater unit and the receiver icon
will be displayed on the slave unit. The master's
LED indicator will be red (indicating transmitting)
and the slave's LED indicator will be green
(indicating receiving). During cloning, the two-digit
counter will increment one digit at a time on each of
the displays.
When cloning is successful, "End" will be shown on the displays. If "Err0r" is shown on the
slave's display, press the [MONI] button on the slave unit and repeat steps 4 – 6 with the
slave radio. Make sure the master and slave units are in close proximity of each other.
2.1.5. Programming By Computer
Programming a radio from a computer is not covered in this manual. Contact RELM
Communications for the programming cable (PCRP) and software (RESRP99).
Page 24
Master Display
RELM Communications
Advertisement
