Advertisement
If any of the functions in Table 2.2 and Table 2.3 are set to "Off", the related setting shown in
table 2.4 can be set, but the setting will not be recognized.
Function Name
2-TONE/ DTMF
2. [SCN]
6. Priority
7. Priority CH
8. Look Back A
9. Look Back B
10. Revert CH
11. Dwell Time
12. Dropout Delay Time
14. TOT Pre-Alert
15. TOT Rekey Time
16. TOT Reset Time
31. Connect ID
32. Disconnect ID
38. Intermediate Code
40. Unsquelch Time
41. Call Alert/Transpond
Table 2.4 – Disabled Function Conditions
2.1.3.3. Dealer Mode - Enhanced Global Settings
To place the unit into the "Dealer Mode" for editing the enhanced global settings, do the
following:
1. While pressing and holding the [LAMP] and [DIAL] buttons, switch the power "on". After
2 seconds the radio enters the dealer mode and "SEL" appears on the display.
2. While in dealer mode, press [LO] to enter the Enhanced Global Settinhgs mode.
Table 2.5 shows the function number and function options that can be selected while in this
mode. While in this mode, the Channel Selector knob is used to set functions "ON" or "OFF" or
to select the setting. After a function is set, pressing the [PTT] button stores the setting and
increments the menu to the next function option. Also, when the [PTT] button is pushed, a beep
will sound to confirm the setting.
Pressing the [LO] button at any time while reviewing the function options will cause the unit to
exit the selection mode and revert back to the dealer mode screen. The current function option
RELM Communications
Setting
DTMF
TO
Fixed, Selected
Priority, Priority + Selected
Disable Condition
37. DTMF signaling is OFF
7. Priority is fixed or selected.
2. [SCN] is OFF
6. Priority is OFF or fixed.
6. Priority is OFF
6. Priority is OFF
6. Priority is OFF
2. [SCN] is OFF
2. [SCN] is OFF
13. Time Out Time is OFF
13. Time Out Time is OFF
13. Time Out Time is OFF
29. PTT ID is OFF or disconnected and 30. Dial ID is
OFF
29. PTT ID is OFF or connected and 30. Dial ID is
37. DTMF signaling is OFF or is code SQ.
37. DTMF signaling is OFF.
37. DTMF signaling is OFF.
Page 17
Advertisement
