Advertisement
TX TONE
Disable
CTCSS
67.0 Hz – 250.3Hz
CDCSS
DTMF or TWO
Disable
TONE
DTMF
SIGNALING
Two Tone
ANI
Disable
Enable
SCAN
Delete
Add
BUSY
Disabled
CHANNEL
Enabled
LOCKOUT
CLOCK SHIFT
Disabled
Enabled
TX POWER
High
Low
BANDWIDTH
Wide Band
Narrow Band
DTMF ID
4
CODE
4
Step 8 will not show unless DTMF is selected in step 1 of this section.
Page 20
OFF
Disables CTCSS or DCS
67.0
Selecting the [LO] key switches it from OFF to the first
CTCSS tone. Rotate the channel selector to move the
tone frequency up or down until the desired tone
frequency is reached.
023
Selecting the [LO] key again switches it from CTCSS to
the first DCS tone. Rotate the channel selector to move
the DCS code up or down until the desired code is
reached.
1 OFF
No DTMF or Two Tone signaling is required.
1 1
Allows DTMF signaling on selected channel.
1 2
Allows Two Tone signaling on selected channel.
2 OFF
Disables this feature.
2 2
Allows the DTMF ANI to be transmitted every time the
PTT switch is pressed.
3 dEL
Deletes the channel from the permanent scan list.
3 ADD
Adds the channel to the permanent scan list.
4 OFF
Busy Channel Lockout is disabled.
4 On
Busy Channel Lockout is enabled.
5 OFF
Disabled
5 On
Used to shift the synthesizer clock frequency in order to
reduce or resolve interference when a channel is
experiencing a "self-quieting spur "or a "birdie frequency".
6 H
High power is 5 watts. When set to Hi, pressing the [Lo]
button toggles the power from 5 watts to 1 watt or from 1
watt to 5 watts.
6 L
Low power is 1 watt. The [Lo] button will not toggle the
channel to high power. Always set to low power.
7 b0
Receiver bandwidth is +/-25KHz, Transmit deviation is
less than +/-5KHz.
7 b1
Receiver bandwidth is +/-12.5KHz, Transmit deviation is
less than +/-2.5KHz.
8 12345
The DTMF code must have a minimum of 3 digits, but no
more than 10 digits.
RELM Communications
Advertisement
