Advertisement
LOOK
9
BACK B
REVERT
10
CHANNEL
TX-SCAN
11
DELAY
TIME
DROP OUT
12
DELAY
TIME
RELM Communications
9
0.5s ~ 5.0s (0.5s
Default = 2
steps)
sec.
Selected
10
Last Call
10
Last Used
10
Selected + Talk Back
10
Priority
10
Priority + Talk Back
10
11
0.5s ~ 5.0s
Default = 3
(0.5s steps)
sec.
11
12
0.5s ~ 5.0s
Default = 3
(0.5s steps)
sec.
12
Conditions: 1. The priority feature is enabled. 2.
The Scan feature is enabled. 3. The radio is in the
0.5
scan mode. 4. The radio stops on an active
channel that is not the priority channel. 5. A signal
is detected on the priority channel, but the
signaling squelch (CTCSS, CDCSS, 2-Tone, or
DTMF) is not the same as the priority channel.
Look Back B is the time intervals that the priority is
checked for activity while receiving on the non-
priority channel.
Starts scanning or resumes scanning from the
selected channel. When scanning and the PTT
1
button is pressed, it will transmit on the last
channel to be selected by the channel selector
even if a call is being received on another channel.
Starts scanning or resumes scanning from the last
channel that received a call. When scanning and
2
the PTT button is pressed, it will transmit on the
last channel that received a call.
Starts scanning or resumes scanning from the last
channel that was transmitted on. When scanning
3
and the PTT button is pressed, it will transmit on
the last channel that was transmitted on even if a
call is being received on another channel.
Starts scanning or resumes scan from the selected
channel. When scanning and the PTT button is
pressed, it will transmit on the last channel to be
selected by the channel selector; or if a call is
4
received and the PTT button is pressed, it will
transmit on the received channel (the PTT must be
pressed before the Drop Out Delay Time ends,
otherwise it will transmit on the last channel
selected).
Starts scanning or resumes scanning from the
priority channel. When scanning and the PTT
5
button is pressed, it will only transmit on the priority
channel. When in the manual mode, the radio will
transmit on the selected channel
Starts scanning or resumes scanning from the
priority channel. When scanning and the PTT
button is pressed, it will transmit on the priority
channel; or if a call is received on a non-priority
6
channel and the PTT button is pressed, it will
transmit on the received channel (the PTT must be
pressed before the Drop Out Delay Time ends,
otherwise it will transmit on the priority channel).
0.5
The period of time that the radio stays on a
channel after a transmission has been made
before it resumes scanning.
5.0
0.5
The period of time before the radio resumes
scanning after a received channel becomes
inactive.
5.0
Page 11
Advertisement
