Advertisement
2.1.4. Cloning
Cloning allows the memory contents of one unit (master) to be transferred to another unit
(slave). There are two methods that can be used for cloning the RPV599 series radio.
Wired – Cloning using the CCRP cloning cable.
Wireless – Over the air cloning.
2.1.4.1. Wired Cloning
1. Turn both the master and slave units "off".
2. Connect each end of the CCRP cable into the respective microphone jacks of the radio.
3. Turn the slave unit "on".
Do the following with the master radio:
4. While pressing and holding the [LAMP] and
[DIAL] buttons, switch the power "on". After
2 seconds the radio enters the dealer mode
and "SEL" appears on the display.
5. Press the [LAMP] button to enter the clone
mode. "-C-" will appear in the display.
6. Press the [MONI] button to transmit the data
to the slave unit. While the data is being
transferred, the red LED will light on the
slave unit and the busy icon on the display
will flash. When the transfer is complete.
Both displays will show "End".
7. To clone another slave unit, turn off the slave unit, remove the CCRP cable from the
slave unit, connect the CCRP to another slave unit, and switch the unit on.
8. Repeat steps 5 and 6 to clone more units.
2.1.4.2. Wireless Cloning
Do the following with the slave radio:
1. Remove the antenna.
2. While pressing and holding the [LAMP] and [DIAL]
buttons, switch the power "on". After 2 seconds the
radio enters the dealer mode and "SEL" appears on
the display.
3. Press the [MONI] button to enter the wireless clone
mode. A frequency will appear in the display. Adjust
the channel select knob to adjust the frequency to
the desired frequency to receive data on. Note:
Pressing the [LAMP] button while turning the
channel selector, will change the frequency in 1
MHZ steps.
RELM Communications
Master Display
Slave Display
Slave Display
Page 23
Advertisement
