Storage; Trouble Shooting Guide - Gastroback Design Espresso Advanced Plus Operating Instructions Manual

cleAning the outer housing / cup WArMing plAte
The outer housing and cup warming plate can be cleaned with a soft, damp cloth. Then
polish with a soft, dry cloth. Do not use abrasive cleansers, pads or cloths which can scratch
the surface.
cleAning the Drip trAY
The drip tray should be removed, emptied and cleaned at regular inter-
vals, particularly when the drip tray full indicator is showing ›Empty Me!‹.
Remove grid, compartments and ›Empty Me!‹ indicator from the drip
tray. Dispose of the grounds from the dry compartment into the waste
bin. Wash the drip tray with warm soapy water, using a non-abrasive
washing liquid, rinse and dry thoroughly. The ›Empty Me!‹ indicator can be removed from
the drip tray by pulling upwards to release the side latches. The drip tray base and cover
are dishwasher safe.
cleAning the storAge trAY
The storage tray can be removed after the drip tray is removed then
cleaned with a soft, damp cloth (do not use abrasive cleansers, pads or
cloths which can scratch the surface).

storAge

Before storing, press the POWER-button to off, turn the steam dial to off and unplug. Empty
the water tank and the drip tray. Ensure the machine is cool, clean and dry. Insert all ac-
cessories into position or into the storage tray. Store upright. Do not place anything on top.
WArning:
Do not immerse power cord, power plug or aplliance in water or any other
liquid. The water tank should never be removed or completely emptied during decalcifying.

trouBle shooting guiDe

PROBLEM
When the machine is switched
on, the steam and hot water
lights are flashing.
Espresso does not run through.
Espresso runs out too quickly
POSSIBLE CAUSES
Steam dial is not in STAND BY-position
Machine is not turned on or plugged in
Water tank is empty
Espresso grind tamped too firmly
The filter is blocked
The espresso grind is too coarse
Ground espresso not tamped firmly enough Refer to ›Tamping The Ground Espresso‹, page 50.
WHAT TO DO
Turn the Steam dial to STAND BY-position. Machine
will commence normal heat up procedure.
Ensure the machine is plugged in and the POWER
button is pressed to on.
Refer to ›Filling The Water Tank‹, page 55.
Refer to ›Tamping The Ground Espresso‹, page 50.
Clean the filters. Refer to ›Cleaning The Filters‹,
page 57.
Ensure you use a suitable espresso grind.
58