TDK-Lambda Genesys Series User Manual page 43

11.6.2. Read the Hostname
The hostname (see section 4.5) may be read with this query
Syntax:
Example:
Response:
Example:
11.6.3. Read the IP Address
The IP address (see section 4.4) may be read with this query
Syntax:
Example:
Response:
Example:
11.6.4. Read the MAC Address
The MAC address may be read with this query
Syntax:
Example:
Response:
Example:
11.6.5. Reset the LAN Settings
WARNING: Sending this command could disable the LAN connection to the power supply
This command will reset the LAN settings to the factory default state. The effect of this include changing
the IP address and hostname, so LAN communication could be lost.
Therefore, only use this command as a diagnostic tool. See section 5.3 for a description of the LAN reset
condition.
Syntax:
Example:
11.6.6. Serial Command Pass-Through
The Genesys™ power supply RS-232/485 (serial) command set has several functions that cannot be
implemented by the LAN SCPI command set. For example, power supply calibration is done using the RS-
232 port, so the LAN port has no calibration commands.
The serial command pass-through allows any serial command to be sent through the LAN SCPI port.
The response message from a pass-through command is the same response as seen over the serial port.
Unlike the SCPI commands, all pass-through commands have a response message that may be read back.
Refer to the GenesysTM Technical Manual for a description of the RS-232 & RS-485 Remote Control command
set
For socket programs, you may not use a semi-colon terminator.
Syntax:
Parameter:
SYSTem:COMMunicate:LAN:HOST?
SYST:COMM:LAN:HOST?
The hostname string, up to 15 characters long
is a typical default hostname
GEN7p5-1000-123
SYSTem:COMMunicate:LAN:IP?
SYST:COMM:LAN:IP?
The IP address string, up to 15 characters long
is a typical default IP address
169.254.9.35
SYSTem:COMMunicate:LAN:MAC?
SYST:COMM:LAN:MAC?
The MAC address string, 17 characters long
is a typical default IP address
00:19:f9:00:24:3b
SYSTem:COMMunicate:LAN:RESet
SYST:COMM:LAN:RES
DIAGnostic:COMMunicate:PASSthrough <string>
is any RS-232/485 command or query
<string>
(no quotes are used to enclose the string)
43