Connecting And Signaling Elements - Camozzi D Series Instruction Manual

If the device is used to operate an actuator whose accidental movement can generate a hazard,

provide for appropriate locking devices for the moving part of the actuator.
Make sure the connectors are connected and fastened correctly.

Use only power supplies capable of ensuring safe electrical disconnection of the voltage supply

according to IEC 742 / EN 60742 / VDE 0551 with a minimum insulation resistance of 4 kV Protected
Extra Low Voltage (PELV).
It is the user's task to adopt the necessary measures to prevent damage to the system caused by non-

periodic overvoltage peaks on the power lines following power cuts on high energy equipment.
Voltage interruptions are allowed according to the PS2 severity level.

6.1

Connecting and signaling elements

Operating
status LED
Diagnostic
Led
D-Sub Connector
Instruction manual
Series D multipole size 1
Reset switch
Valves Led
Bobine
Coil
V1 V2
9
5000026173
Version 00