General Recommendation - Camozzi D Series Instruction Manual

5000026173
Instruction manual
Series D multipole size 1
Version 00

2. General recommendation

Please respect the recommendations for safe use described in this document.
• Some hazards can be associated with the product only after it has been installed on the machine /
equipment. The end user is responsible for identifying these dangers and reducing the risks associated
with them.
• The products covered by this manual can be used in circuits that must comply with EN ISO 13849-1.
• For information regarding the reliability of the components, contact Camozzi.
• Before using the product, carefully read the information contained in this document.
• Keep this document in a safe and handy place throughout the life cycle of the product.
• Transfer this document to any subsequent holder or user.
• The instructions contained in this manual and further information can be found using the following
references:
o Website http://www.camozzi.com
o Camozzi general catalog
o Technical assistance service
• Assembly and commissioning must only be carried out by qualified and authorized personnel, according
to these instructions.
• It is the responsibility of the system / machinery designer to correctly choose the most appropriate
component according to the required use.
• The use of suitable protections is recommended to minimize the risk of personal injury.
• For all those situations of use not covered in this manual and in situations where damage to property,
persons or animals could be caused, contact Camozzi first.
• Do not carry out unauthorized modifications on the product. In this case, any damage caused to people
or animals is to be considered the responsibility of the user.
• It is recommended to comply with all the safety regulations affected by the product.
• Do not intervene on the machine / system unless after checking that the working conditions are safe.
• Before installation or maintenance, make sure that the specific safety lockout positions are activated,
then cut off the power supply (if necessary) and the pressure supply of the system, discarding all the
residual compressed air present in the system and deactivating the residual energy stored in springs,
condensers, receptacles and gravity.
• After installation or maintenance, it is necessary to reconnect the pressure and electrical supply (if
necessary) of the system and check the regular operation and tightness of the product. In the event of a
leak or malfunction, the product must not be put into operation.
• The product can be put into operation only in compliance with the specifications indicated, if these
specifications are not respected the product can be put into operation only after authorization by Camozzi.
• Avoid covering the appliances with paints or other substances that reduce heat dissipation.
6