Table of Contents
Advertisement
4. Product storage and transport
Adopt all measures possible to avoid accidental damage to the product during transport, and when
available use the original packaging.
Observe the specified storage temperature range of -10 ÷ 50 °C.
5. System description
The D Series is a valve island equipped with COILVISION technology that allows you to monitor and predict
the state of wear and efficiency of some parts of the individual solenoid valves. Through this monitoring
and predictive diagnostics system it is possible, for example, to know the electricity consumption and the
possible overheating of the coil. The detected data, alarms and health status can be transmitted via cable
to a PLC or via WLAN to an IIoT Gateway for subsequent sending to the Cloud. The D Series is suitable for
use in applications with limited installation space without penalizing the flow rate.
Available with connection integrated in a D-sub connector, it allows to cover the needs of all industrial
applications.
COILVISION technology has been developed to constantly monitor the functional parameters of the
electropilot which operates the spool via air. Each actuation of the electropilot, in different cyclic
configurations and environmental conditions, is analyzed to acquire information which, processed by
software algorithms, allows to diagnose and predict the health of the component.
Installation and commissioning
6.
During the unpacking phase, be very careful not to damage the product.
Check for damage due to transportation or storage of the product.
Separate the packaging materials in order to allow their recovery or disposal in compliance with the
regulations in force in your country.
Before putting the component into operation, check that the declared characteristics and
performances correspond to those required.
During the installation of the component, provide for specific surge protection devices.
During the installation of the component, check that there is no danger due to mechanical movements.
Install the component in an area where the set-up and maintenance phases are easily performed and
cannot create dangers for the operator.
Close any unused connections with the appropriate covers or protective caps, in the case of the 3/5
and 82/84 exhaust channels with appropriate silencers.
The components must be fixed correctly, using the appropriate anchors, where available, and checking
that the fixing remains effective even in the presence of high cycles or strong vibrations.In presenza di
forti vibrazioni prevedere appositi dispositivi/sistemi in grado di attutirne l'effetto sul componente.
Provide for the installation of dehumidifiers in order to avoid the formation of humidity and
condensation in the internal components.
Instruction manual
Series D multipole size 1
8
5000026173
Version 00
Advertisement
Table of Contents
