Xycom XVME-956 Series Manual page 104

•
SHOW4I29
This utility program displays some of the current XVME-956/411 setup parameters. The
COMPATIBLE option and the PROMLOC option are not readable, so they are not displayed.
SHOW4I29 is invoked with the hexadecimal port address on the command line:
SHOW4I29 3 0 0
Because it is possible to forget the port location of a XVME-956/411 card, the port address on the
command line can be replaced with 'S'. This causes SHOW4I29 to look for the XVME-956/411 card
by probing all of the possible XVME-956/411 I/O addresses. Yo u should not use the (S)earch option if
you know the XVME-956/411 port address, as it is not guaranteed to work in all cases.
•
Default Configuration
The default EEPROM configuration on XVME-956/411 card as shipped from the factory is as follows:
•
SHOW4I29 should not be run after network software is installed or
unpredictable behavior may result.
MAINMODE
COMPATIBLE
PORTADD
INTERRUPT
PROMLOC
CABLETYPE
FASTREAD
FASTIO16
FASTCHRDY
NOTE
IOMAPPED
YES
300
IRQ
NONE
THIN
NO
NO
NO
XVME-956 Manual
October 1994
6-9