Vehicle Connection Diagnosis; Vehicle Connection Test; Precautions Before Use - Xtool PS80 User Manual

PS80 Diagnosis System

3. Vehicle Connection Diagnosis

3.1. Vehicle Connection Test

a. Turn on PS80 tablet
b. Connect cables and PS80 in following order: ①→②→③→④
c. Switch on the ignition and tap on PS80 application to test vehicles. (Shown as follows)
① PS80 Mainframe
② Main Test Cable
③ OBDII Connector
④ Vehicle

3.2. Precautions before Use

3.2.1. The vehicle power supply has to meet the normal voltage limits DC 9-12V.
3.2.2. Users should check the position of the DLC port and ensure the OBDII 16pin
connector and the DLC port are correctly aligned before attempting to connect.
3.2.3. When taking some special functions tests, users are required to operate the
device according to operating instructions. For vehicle, it has to strictly meet the
requirements, for example, the conditions that some vehicle models need to be
reached are as follows: engine temperature 80℃/105℃, turn off the loads (such
as headlights, air-conditioner, etc.), put accelerator pedal in released position, etc.
3.2.4. If users can not find the tested vehicle model or electronic control system in
the PS80 test menu, they may need to update the software or consult Xtool
technical service department.
3.2.5. Please ensure that only official XTOOL cables and connectors are used to
prevent damage to the unit.
3.2.6. Before powering off the unit, please ensure that you cancel or complete the
6