Table of Contents
Advertisement
7 – 1
Installing the negative brake
Only one person is needed to carry out the modification.
– Remove the wheel housings. Loosen the M16 screws making sure not to lose the washers
– Gently loosen the M16 nuts (framed in red) so as to move the conveyor in wards by 10 mm
UNDERSIDE VIEW OF THE BRV
– Install the new housings fitted with brakes. Loosen the springs and tighten the M16 screws
(framed in red).
(red arrow). When the conveyor has been moved, tighten the nuts back up.
with their washers (framed in red).
Société des Anciens Établissements L.GEISMAR – Prohibited Reproduction ©
Chapter 7 – Optional equipment
Page 37
Advertisement
Chapters
Table of Contents
