Special Safety Instructions; Equipment With A Combustion Engine; Equipment With Electrical Devices - GEISMAR BRV Operation & Maintenance Instructions Manual

F
OLLOWING A PROLONGED NON
Check the tightening and connections of the fasteners.
If a deformation or an abnormal wear is noted, the parts must be replaced.
H
ANDLING OF FLUIDS
The handling of fluids (fuels, coolants, battery fluids, cleaning fluids, oils, etc...) and their
storage has to comply with the regulations in force.
Carefully read the product label (precautions of use and storage).
In any case, these fluids must be sorted by nature in tight containers and clearly marked.

Fluids can be harmful. Avoid any contact with skin or eyes. In case of splatter,
rinse copiously the soiled areas with clean water without delay and visit a doctor.
1 – 4

Special safety instructions

1 – 4 – 1

Equipment with a combustion engine

Never start the combustion engine otherwise than with the device provided for this purpose.
Exhaust gases are harmful, avoid exposure to them and always start or use the machine with
the combustion engine in a well-ventilated environment.
During fuel refill or fuel handling, the operator must make sure that he operates in optimal
safety conditions.
In the event of spillage, clean the tank with dry clean cloths.

Always perform refill of fuel or maintenance liquids with the combustion engine
switched off and cold and abide by the label warnings and safety precautions.
These operations must be carried out far from any heat source; mobile phones
must be switched off. A spark could trigger an explosion and cause grievous
bodily harm or death. Fuel splatters or fuel leakage onto electrical components or hot
surfaces can lead to fire.

Unless otherwise specified, do not carry out adjustments with the engine running
1 – 4 – 2

Equipment with electrical devices

Personnel intervening on a machine with electrical devices must be trained and authorized.
Protection measures must be implemented to ensure optimal safety conditions for their work
marking of the intervention; electric insulation of the equipment, posting safety precautions for
works on or close to the machine, supply of individual protection equipment when needed....
O
BSERVE FOLLOWING GUIDELINES
– Never bridge the terminals of the starter or of the batteries. This bypass might disable the
– Keep the switch box from water and humidity (might cause several accidents with harm to
– Do not bypass open fuses, respect the current limitation;
– Periodically check the good state of battery contacts;
-
USE OR DURING A PERIODIC CONTROL
emergency shutdown switch and damage electronics or electrical circuitry;
persons or material damages);
Société des Anciens Établissements L.GEISMAR – Prohibited Reproduction ©
Page 11