Table of Contents
Advertisement
Retooling
The following hazards may be present during tooling of the unit.
Retooling presents all the hazards of tooling. It is therefore
recommended observing all safety precautions from the Tooling
section prior
Retooling / Tooling presents the hazard of function-change. Changing
tooling changes the original operating conditions of previous tooling or
the unit itself. It is therefore recommended to always be aware of the
resulting function and effective operating range of the new, resulting-
unit from retooling / tooling.
Retooling is necessary when different products are processed on the machine (product
change).
A product change necessitates various retooling and/or modification measures.
The following operations have to be performed:
Installation of Additional Dial Plates and Tooling
It is highly recommended that additional mounting plates be installed using only the supplied
fixture holes. This is to ensure that concentricity and accuracy are maintained.
Installation of Safety Equipment
It is the responsibility of the operator to properly size, select and fit safety equipment.
It is forbidden to proceed with any Life-Phase of the unit or parent prior
to application of Unit Safety Equipment.
Packaging Disposal
Packaging should be stored or discarded in compliance with national and local regulations.
The following hazards may be present during this Life-Phase of the
unit.
32
Set-up
and
tooling
Advertisement
Table of Contents
