Transportation Outside Of Packaging; Transportation Damage; Intermediate Storage - DE-STA-CO MDE Series Installation Manual

Transportation Outside of Packaging


EQUIPMENT:

Lifting straps/chains

Metric eyebolts

Forklift/Crane

Proper PPE: gloves, glasses, footwear

Level

PREPARATION:
01.
02.
03.

EXECUTION:
04.
05.
06.
07.

Transportation Damage


Inspect the following areas of the unit for any signs of damage after
transportation:

Housing Assembly: dents, cracks, bends, leaks

Output Assembly: seal (leaks), dents, looseness, flatness (a level
should be fine in this application as a noticeable change in flatness due
to damage is the measurement being observed not the function
parameter).

Input Assembly: seal (leaks), dents
In the event of damage after transportation do not proceed
with installation until contacting the manufacturer.

Intermediate Storage


In the event of a need for storage for a delayed period of time (1 week +)
retain the unit within its original packaging.

The original packaging is conditioned to preserve the unit in most
environmental settings (save extreme ones).
Carefully unpack the unit making sure to preserve packaging.
Review and verify contents comply with the packaging list.
Inspect and document key unit areas for damage or leaks.
Place eye-bolts in lifting holes (FIG. X); firmly screw into
place.
Attach lifting straps/chains to eyebolts.
Use a forklift/crane to lift unit.
Move the unit to desired location of installation and slowly
place on the floor in a safe, pre-assigned area marked
appropriately.
25
Transport