Operating Sequence; Washing; Load The Laundry; Measure Out The Detergent - Zanussi WD 1250 W Instruction Booklet

Operating Sequence

WASHING

Before the first wash we recommend that you pour 2
litres of water into the main wash compartment
the detergent drawer in order to activate the
ECO valve. Then run a cotton cycle at 60°C, with the
machine empty, in order to remove any manufacturing
residue from the drum and tub.
Pour half a measure of detergent into the main wash
compartment and start up the machine.

1.Load the laundry

Open the door.
Place the laundry in the drum, one item at a time,
shaking them out as much as possible.
Close the door.

2.Measure out the detergent

Pull out the dispenser drawer until it stops. Measure out
the amount of detergent required and pour it into the
main wash compartment
If you wish to carry out the prewash, pour detergent into
the appropriate compartment marked
3.Measure out the fabric
softener
If required, pour fabric softener into the compartment
marked , without exceeding the «MAX» mark.
Close the drawer gently.
of
.
.

4. Switch the machine on

Press the ON/OFF button to switch the machine on. The
display will show three blinking dashes or a blinking
zero. The light above the button will light up.
5. Select the desired programme/
fabric
Press the FABRICS button repeatedly, in order to select
the desired programme/fabric. The relevant light will
light up.
The lights relevant to the phases that form the
programme will light up.
The display will show the duration of the selected
programme, calculated on the basis of the maximum
load for each type of fabric. The START/PAUSE button
light will start flashing.
If the load of laundry to be washed is small, at the
beginning of the cycle the display will still indicate the
duration relevant to the maximum load. The duration
value will be gradually adjusted during the execution of
the cycle.
11