Dear customer, Please read these operating instructions carefully and pay particular attention to the safety notes indicated in the first pages. We recommend that you keep this instruction booklet for future reference and pass it on to any future owners. Transport damages When unpacking the appliance, check that it is not damaged.
Contents Warnings Maintenance Door seal Disposal Bodywork Detergent dispenser drawer Tips for environmental protection 5 Drain filter Water inlet filter Technical specifications Emergency emptying out Frost precautions Installation Unpacking Something not working? 29-30 Positioning Water inlet Water drainage Electrical connection Your new washing-dryer Description of the appliance Door locked pilot light...
Warnings The following warnings are provided in the interests of overall safety. You must read them carefully before installing or using the appliance. Installation • Use only the recommended quantities of fabric softener. An excessive amount could damage the • All internal packing must be removed before using laundry.
Child safety • Make sure that children or pets do not climb into the drum. • Children are often not aware of how dangerous • When the appliance is to be scrapped, cut off the electrical appliances can be. When the machine is electrical supply cable and destroy the plug with working, children should be carefully supervised the remaining cable.
Technical specifications DIMENSIONS Height 85 cm Width 60 cm Depth 58 cm WASHING DRYING MAXIMUM LOAD Cotton 5.5 kg 2.75 kg Synthetics Delicates Woollens SPIN SPEED 1600 rpm max. POWER SUPPLY VOLTAGE/FREQUENCY 220-230 V/50 Hz TOTAL POWER ABSORBED 2200 W MINIMUM FUSE PROTECTION 10 A WATER PRESSURE...
Installation Unpacking Positioning Install the machine on a flat hard floor. All transit bolts and packing must be removed Make sure that air circulation around the machine is before using the appliance. not impeded by carpets, rugs etc. Check that the machine does not touch the wall or other kitchen You are advised to keep all transit devices so that units.
Water drainage Electrical connection The end of the drain hose can be positioned in three This machine is designed to operate on a 220-230 V, ways: single-phase, 50 Hz supply. Hooked over the edge of a sink using the plastic Check that your domestic electrical installation can hose guide supplied with the machine.
Your new washer-dryer This new washer-dryer, which is fitted with the Jet system, patented Zanussi, meets all modern needs for effective treatment of laundry with low water, energy and detergent consumption. Further savings are achieved by washing small loads of laundry, since water and electricity consumption is proportional to the quantity and type of laundry being washed.
Control panel 1 Function of MEMORY buttons Recall There are 4 Memory buttons at your disposal to A memorized programme can be recalled pressing memorize and recall the four washing programmes the corresponding Memory button. that are used more frequently. •...
4 TEMPERATURE button Main switch Pressing this button you can modify the washing Pressing the ON/OFF button the machine is temperature proposed by the machine. switched on and off; the machine can be programmed when three dashes are blinking on the display.
There are 3 possibilities to drain the water: Prewash • Choose the “Drain” programme. The machine carries out a prewash at 30°C max.; The water is drained without spin. the washing programme will last for about 20 • Press only the Start/Pause button. minutes longer.
Note • If the laundry is not taken out within 18 hours, the machine will drain the water automatically. • At the end of the soak time, that is set by the user, and after the draining of the water, a zero appears on the display.
Now you can set the programme. Drying time The selected drying time is displayed in minutes or hours and minutes. Duration After starting the programme, the remaining time is After having set the programme, the display shows updated every minute. the duration in hours and minutes (ex..
10 “START/PAUSE” button Now the countdown of the set time begins (it decreases by one unit every hour). This button has 3 functions: During these hours it is possible, when the Pause Start – Pause – Drain button is pressed, to open the door and to add some clothes.
Laundry weights Washing hints The following weights are indicative: bathrobe 1200 g Sorting the laundry napkin 100 g Follow the wash code symbols on each garment quilt cover 700 g label and the manufacturer’s washing instructions. Sort the laundry as follows: sheet 500 g whites, coloureds, synthetics, delicates, woollens.
Ink: depending on the type of ink, moisten the fabric Quantity of detergent to be used first with acetone (*), then with acetic acid; treat any The type and quantity of detergent will depend on residual marks on white fabrics with bleach and then the type of fabric, load size, degree of soiling and rinse thoroughly.
Drying symbols on garment labels Drying hints Always look at the garment label to check whether As a dryer, the machine works on the condensation garments can be machine dried. principle. The following symbols refer to drying: Therefore, the water tap must be open and the drain hose must drain water into a sink or into Machine drying is usually possible the drain pipe, even during the drying cycle.
International wash code symbols These symbols appear on fabric labels, in order to help you choose the best way to treat your laundry. Energetic wash Max. wash Max. wash Max. wash Max. wash temperature temperature temperature temperature 95°C 60°C 40°C 30°C Hand wash Do not...
3. Measure out the additive Operating sequence Pour any liquid additives, to soften or starch the laundry, in the compartment Washing only Do not exceed the MAX level. Before washing your first load of laundry, we recommend that you run a cotton cycle at 60°C, with the machine empty, to remove any manufacturing residue from the drum and tub.
6. Choose the temperature 9. Set the delayed start Press the button until the desired washing If you want to delay the start, set the hours with the temperature illuminates. “DELAY START” button 7. Select the spin speed or the 10.
• If necessary press the “DELAY START” button when you want to delay the start of the programme • Start the machine by pressing the “START/PAUSE" button. Setting with the Special Programmes • Switch the machine on by pressing the ON/OFF button.
Drying only Automatic washing and drying (NON-STOP programme) Warning! Do not exceed the maximum laundry loads: Warning! For NON-STOP programmes, it is also - 2.75 kg for linen and cottons essential not to exceed the maximum load sizes of 2.75 kg for cotton and 2 kg for synthetics. kg for synthetics.
Programme chart WASHING PROGRAMMES Consumption* Available Programmes Fabrics Max. load Energy Water Time options litres min. White cotton 95° White cotton, e.g. working clothes PREWASH normally soiled, bed linen, table linen QUICK WASH and underwear, towels RINSE HOLD 5.5 kg SPIN SPEED White cotton economy White cotton economy, e.g.
Programme chart SPECIAL PROGRAMMES Consumption* Programme Running of Available Programmes Max. load Energy Water Time description programmes options litres min. Soak For heavily Soak at 30°C soiled fabrics, Stop with water in not for wool To drain: press the START/PAUSE 5.5 kg button.
Programme chart Timed drying Degree of Drying time Type of fabric Max. load Spin speed drying mins 2.75 kg 1600 Extra dry Cotton and linen Ideal for (bathrobes, bath towelling towels, etc.) materials 1.5 kg 1600 2.75 kg 1600 Cotton and linen (towels, T-shirts, bathrobes) Store dry (*)
Maintenance 1. Door seal Detergent can also accumulate inside the drawer recess: clean it with an old toothbrush. Refit the Check from time to time the door seal and eliminate drawer after cleaning. eventual possible objects that could be trapped in the fold.
5. Water inlet filter 7. Frost precautions If you notice that the machine is taking longer to fill, If the machine is installed in a place where the check that the filter in the water inlet hose is not temperature could drop below 0°C, proceed as blocked.
Something not working? Problems which you can resolve yourself. During machine operation it is possible that one of the following alarm codes appears on the display: - E10: problem with the water supply - E20: problem with water draining - E40: door open - EF0: the drain filter is clogged.
Problem Possible cause • The door will not open: • The water level is above the bottom edge of the door. • The machine is heating the water or drying. • The drum is turning. The door can only be opened when the relevant light has gone out.