Download  Print this page

Skip/Reset Button - Zanussi WD 1250 W Instruction Booklet

Zanussi owners manual front-load washer wd 1250 w
Hide thumbs


10 START/PAUSE button
This button has three functions:
• Start: after you have selected the desired programme
and options, press this button to start the machine. The
light above the button will stop flashing and remain lit.
If you have selected a delay time by means of button
12, the countdown will begin and will be shown on
the display.
• Pause: when you press this button again, the
programme in progress is interrupted. The light above
the button will start flashing. To restart the
programme, press the button again.
Important! You must set the washing machine to
PAUSE before you make any change in the programme
in progress.
• Draining of water and spinning after the execution
of programmes with the RINSE HOLD option.

11 SKIP/RESET button

This button performs two functions:
- Clears the memory
- Selects special programmes
At the end of every programme the RESET button must
be pressed once or repeatedly to clear the programme
memory. This will be confirmed by three dashes,
flashing in the display.
If the previous programme is not cleared, the display
will show a "
" flashing and an audible signal will
sound, when you switch the machine on.
Selecting a special programme:
A wash programme must be selected in the normal way.
(START button not pressed)
A normal wash cycle consists of the following phases,
Wash - Rinses - Spin and is confirmed by the
illumination of the corresponding LED,s.
To select rinse & spin, press the SKIP button once, the
wash LED goes out.
To select spin only, press the SKIP button twice.
The wash & rinse LED,s go out.
To select Drain press the SKIP button three times, the
wash - rinse - spin LED,s go out.
If you wish to cancel or advance the running
programme to the required phase, PAUSE the cycle and
then press the SKIP button as previously described.


Table of Contents

  Related Manuals for Zanussi WD 1250 W