10 Power Cord Set Requirements; Requirements For All Countries; Requirements For Specific Countries And Regions - HP Spectre x360 14 Maintenance And Service Manual

10 Power cord set requirements

This chapter provides power cord requirements for countries and regions.
The wide-range input feature of the computer permits it to operate from any line voltage from 100 V ac to 120 V
ac, or from 220 V ac to 240 V ac.
The 3-conductor power cord set included with the computer meets the requirements for use in the country or
region where the equipment is purchased.
Power cord sets for use in other countries or regions must meet the requirements of the country and region
where the computer is used.

Requirements for all countries

These power cord requirements are applicable to all countries and regions.
The length of the power cord set must be at least 1.0 m (3.3 ft) and no more than 2.0 m (6.5 ft).
●
All power cord sets must be approved by an acceptable accredited agency responsible for evaluation in the
●
country or region where the power cord set will be used.
The power cord sets must have a minimum current capacity of 10 A and a nominal voltage rating of 125 V
●
ac or 250 V ac, as required by the power system of each country or region.
● The appliance coupler must meet the mechanical configuration of an EN 60 320/IEC 320 Standard Sheet
C13 connector for mating with the appliance inlet on the back of the computer.

Requirements for specific countries and regions

To determine power cord requirements for specific countries and regions, use this table.
Table 10-1 Power cord requirements for specific countries and regions
Country/region
Argentina
Australia
Austria
Belgium
Brazil
Canada
ENWW
Accredited agency
IRAM
SAA
OVE
CEBEC
ABNT
CSA
Applicable note number
1
1
1
1
1
2
75