Solid-State Drive - HP Spectre x360 14 Maintenance And Service Manual

1. Prepare the computer for disassembly
2. Remove the bottom cover
3. Disconnect the battery cable from the system board (see
Remove the front speakers:
1. Disconnect the front speaker cables (1) from the system board.
2. Remove the front speakers (2).
NOTE:
(3). The absence of or damage to these isolators can result in degraded speaker performance.
Reverse this procedure to install the front speakers.

Solid-state drive

To remove the solid-state drive, use this procedure and illustration.
Table 5-4 Solid-state drive description and part numbers
Description
1 TB, M.2 2280, PCIe, NVMe-3 × 4, SS solid-state drive with TLC
1 TB, M.2 2280, PCIe, NVMe, value solid-state drive
512 GB, M.2 2280, PCIe, NVMe-3 × 4, SS solid-state drive with TLC
512 GB, M.2 2280, PCIe, NVMe, value solid-state drive
256 GB, M.2 2280, PCIe-3 × 4, SS solid-state drive with TLC
256 GB, M.2 2280, PCIe, NVMe, value solid-state drive
1 TB, M.2 2280, PCIe + 32 GB, 3D Xpoint solid-state drive
512 GB, M.2 2280, PCIe + 32 GB, 3D Xpoint solid-state drive
40 Chapter 5 Removal and replacement procedures for authorized service provider parts
(Bottom cover on page
When removing the front speakers, make note of the location of the five rubber isolator locations
(Preparation for disassembly on page
37).
Battery on page
37).
38).
Spare part number
L85348-005
L85370-005
L85360-005
L85364-005
L85350-005
L85354-005
L85374-005
L85366-005
ENWW