34.3 Cm (13.5 In) Display Assembly - HP Spectre x360 14 Maintenance And Service Manual

34.3 cm (13.5 in) display assembly

To remove and disassemble the display assembly, use these procedures and illustrations.
Table 5-5 Display assembly descriptions and part numbers
Description
34.3 cm (13.5 in) display assembly:
Antiglare, WLED, touchscreen display assembly with privacy filter in natural silver finish; typical brightness:
1000 nits
Antiglare, WLED, touchscreen display assembly with privacy filter in nightfall black finish; typical brightness:
1000 nits
Antiglare, WLED, touchscreen display assembly with privacy filter in Poseidon blue finish; typical brightness:
1000 nits
BrightView, OLED, touchscreen display assembly in natural silver finish; typical brightness: 400 nits
BrightView, OLED, touchscreen display assembly in nightfall black finish; typical brightness: 400 nits
BrightView, OLED, touchscreen display assembly in Poseidon blue finish; typical brightness: 400 nits
BrightView, WLED, touchscreen display assembly in natural silver finish; typical brightness: 400 nits
BrightView, WLED, touchscreen display assembly in nightfall black finish; typical brightness: 400 nits
BrightView, WLED, touchscreen display assembly in Poseidon blue finish; typical brightness: 400 nits
Before removing the display assembly, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover
3. Disconnect the battery cable from the system board (see
Remove the display assembly:
1. Remove the heat sink shield (1).
2. Disconnect the webcam/microphone module cable (2) from the system board.
3. Remove the WLAN module shield (3).
4. Disconnect the wireless antenna cables (4) from the WLAN module.
NOTE:
WLAN antenna cable connects to the WLAN module #2/Aux terminal.
5. Release the webcam/microphone module cable and the WLAN antenna cables from the retention clip (5)
built into the top cover.
6. Disconnect the display panel cable (6) from the system board.
42 Chapter 5 Removal and replacement procedures for authorized service provider parts
(Bottom cover on page
The #1/Main WLAN antenna cable connects to the WLAN module #1/Main terminal. The #2/Aux
(Preparation for disassembly on page
37).
Battery on page
Spare part number
M22161-001
M22160-001
M22162-001
M22155-001
M22154-001
M22156-001
M22158-001
M22157-001
M22159-001
37).
38).
ENWW