Overview; Powering The Vlb; Front Panel Controls; Power Standby Button - X-Rite Pantone Virtual Light Booth User Manual

OVERVIEW

Powering the VLB

Toggle the power switch located on the back of the VLB to turn it on.
A power standby button is located on the front panel of
the device (see below).
Discontinue use if AC cord is damaged.
Ensure AC cord ratings meet or exceed the device
ratings (see Specifications section in the
Appendices).

Front Panel Controls

Power Standby Button

The power standby button is used to power on and power down the device into a low power state.
To power on the device, press the Power button once. To power down the device, press the power
button again.
To control the main power to the device, see Powering the VLB above.

Up and Down Buttons

The Up and Down buttons are used to adjust the VLB height to allow for the best viewing angle of the
LCD screen.

USB Port

The USB port is used to connect the i1Pro which is required for light calibration.
USB port
Power switch
V i r t u a l L i g h t B o o t h
Back of VLB
Power button
Up button
Down button
9