Cleaning And Servicing - Bosch MUZ5CC2 Instruction Manual

Reversible shredding disc –
coarse/fine
For shredding vegetables, fruit and cheese,
except hard cheese (e.g. Parmesan).
Process on setting 3 (2) or 4 (3).
Marking on the reversible shredding disc:
"2" for the coarse shredding side
"4" for the fine shredding side
Warning!
The reversible shredding disc is not suitable
for shredding nuts. Shred soft cheese with
the coarse side only at setting 7 (4).
Grating disc – fine
For grating raw potatoes, hard
cheese (e.g. Parmesan), chilled chocolate
and nuts.
Process on setting 7 (4).
Warning!
The grating disc is not suitable for grating
soft cheese or slices of cheese.
Grating disc – coarse
For grating raw potatoes, e.g. for
potato pancakes or dumplings.
Process on setting 7 (4).
Working with the continuous-feed
shredder insert
X Fig. G
■ Press Release button and move
the swivel arm to position 2.
■ Insert bowl:
– Tilt the bowl forwards and then set
it down.
– Turn anti-clockwise until it locks into
place.
■ Press Release button and move
the swivel arm to position 1.
■ Remove the protective drive cover.
■ Place the casing on the drive and turn
clockwise as far as possible.
■ Insert the drive shaft.
Warning!
The opening in the drive shaft (Fig. G-7)
must not be blocked with food remnants,
etc.

Cleaning and servicing

■ Place the cutting disc on the disc holder.
Turn the required slicing/shredding side
to face upwards. Place the disc on the
disc holder so that the drive couplings
on the disc holder engage with the disc
openings. The disc must rest on the
lateral lugs of the disc holder.
■ Attach the disc holder to the drive shaft,
rotating it slightly.
■ Attach the lid (note marking, Fig. G-10)
and turn clockwise as far as possible.
■ Insert the mains plug.
■ Turn the rotary switch to the recom-
mended setting.
■ Put the food to be processed in the
feeding tube and press down with the
pusher.
Warning!
Prevent cut ingredients from building up in
the outlet opening.
Tip: To ensure even cutting results, process
thin ingredients in bunches.
After using the appliance
■ Switch off the appliance with the rotary
switch.
■ Rotate the lid anticlockwise and remove.
■ Lift out the disc holder by the recesses.
Take out the discs.
■ Take out the drive shaft.
■ Rotate the casing anticlockwise and
remove.
■ Clean parts.
Cleaning and servicing
W Warning!
Do not use abrasive cleaning agents.
Surfaces may be damaged. Do not wash
components of the cube cutter insert in the
dishwasher or blades will become blunt.
■ Before cleaning the cube cutter insert,
disassemble it.
■ Prerinse all parts under running water.
Clean parts with a brush.
■ Clean the drive shaft only with a damp
cloth.
en
15