Storage; Service And Maintenance - Festool TKS 80 EBS Original Instructions Manual

English
► Set the preset profile setting rail as a rip
fence (see section
► Set the mitre angle of the saw blade (see
section 9.4 ).
► Guide the workpiece along the stop.
10.5 Angled cuts
► For angled cuts, use the spacer wedge with
protective cover (see section
► Use the preset profile setting rail as a cross
and angle stop (see section
► Use the stop to guide the workpiece along.
10.6 Concealed cuts
WARNING
Risk of accidents due to kickback
► The safety equipment must be re-installed
immediately after work that requires the
spacer wedge with protective cover to be
removed.
Complicated concealed cut processes, e.g.
plunge sawing, groove cutting, profile
routing and fluting, are not permitted.
To create concealed cuts, use a feather­
board to ensure that the workpiece is
*
pressed tightly against the table during the
cutting process.
* Not included in the scope of delivery.
For concealed cuts, use the spacer wedge for
grooving (see section
Grooving
► Adjusting the grooving width (see section
9.3 ).
► Set the preset profile setting rail as a rip
fence (see section
► Guide the workpiece along the stop.
► Repeat the process until the required
grooving depth is achieved.
Rebating
Saw the first cut into the thin side of the
workpiece.
► Set the cutting height for the first cut (see
section 9.3 ).
► Set the preset profile setting rail as a rip
fence (see section
The first cut can be made into the thin side of
the workpiece.
► Turn the workpiece.
► Set the cutting height for the second cut
(see section 9.3 ).
40
9.5 ).
9.8 ).
9.5 ).
9.8 ).
9.5 ).
9.5 ).
► Set the preset profile setting rail as a rip
fence (see section
Select the clearance to the rip fence in
such a way that the groove that has al­
ready been sawed is not on the side of
the stop.
The second cut on the thin side of the work­
piece can be produced.

11 Storage

► Pull the mains plug out of the socket.
► Remove the extractor hose.
► Store the accessories included in the scope
of delivery the accessory holders or the
brackets provided for that purpose (see
section 7 ).
► Remove accessories not included in the
scope of delivery.
► Do not store the TKS 80 EBS outside.
CAUTION
Cuts due to protruding parts
► Store the bench-mounted circular saw in
an upright position.

12 Service and maintenance

WARNING
Risk of injury, electric shock
► Always pull the mains plug from the socket
before performing any servicing and main­
tenance work.
► All maintenance and repair work which re­
quires the motor housing to be opened
should always be carried out by an author­
ised service workshop.
WARNING
Incorrect testing may damage the machine
and injure users
► Special information is required for testing
the electrical safety. This is available from
your country's Festool service workshop.
Customer service and repairs must
only be carried out by the manufac­
turer or service workshops. Find the
nearest address at:
www.festool.co.uk/service
9.5 ).