Festool TKS 80 EBS Original Instructions Manual page 33

English
The green
LED [2-4] flash­
es rapidly.
The red
LED [2-5] lights
up constantly.
8.2 Activating the SawStop technology
The SawStop technology is activated upon
delivery and after each time the saw is put
back into operation.
► Press the red STOP button [2-2].
The SawStop technology is activated.
8.3 Bypass mode (deactivated SawStop
technology)
Only use bypass mode to saw conductive
materials. Activate the SawStop technolo­
gy again once finished.
Activating bypass mode
► Press and hold the yellow SawStop
switch [2-6].
The red LED [2-5] flashes once, and then im­
mediately
► press the green START button [2-3].
The TKS 80 EBS starts up.
The red LED [2-5] flashes again once.
► Release the yellow SawStop switch [2-6]
and the green START button [2-3].
The green LED [2-4] flashes slowly.
The red LED [2-5] is not lit.
The TKS 80 EBS is ready for use in bypass
mode.
Deactivating bypass mode (activating the
SawStop technology)
► Press the red STOP button [2-2].
The SawStop technology is activated.
34
The saw blade comes
to a stop during saw­
ing.
Switch the
bench-mounted cir­
cular saw off and on
and saw the work­
piece more slowly.
Or:
The bench-mounted
circular saw is opera­
tional and the yellow
SawStop switch has
been pressed.
Switch the
bench-mounted cir­
cular saw off and on.
8.4 Checking the conductivity of the
material
The conductivity of the material can be checked
in advance without triggering the SawStop tech­
nology.
► Press the green main switch [2-1].
The TKS 80 EBS is ready to use.
► Position the material against the saw blade.
The green LED [2-4] lights up constantly.
The red LED [2-5] flashes rapidly.
Material is conductive: Work in bypass mode
(see section 8.3 ).
The green LED [2-4] lights up constantly.
The red LED [2-5] is not lit.
Material is not conductive: Work with SawStop
technology active (see section
8.5 Triggered SawStop technology
Once the SawStop technology is triggered, the
saw blade comes to a stop under the table. The
cartridge [4-3] and the saw blade [4-1] must be
replaced.
WARNING
Risk of injury due to uncontrolled start-up of
the bench-mounted circular saw
► Always disconnect the mains plug from the
socket before performing any work on the
machine.
Changing the cartridge and saw blade
► Remove the table insert (see section
► Remove the spacer wedge (see section
► Turn the cutting height setting [4-2] to the
minimum of 0 mm and turn it further
against the resistance.
Turn the cutting height setting [4-2] to the
maximum of 80 mm.
The cutting height is set to the maximum of
80 mm.
► Turn the cartridge locking device [4-4]
clockwise by one quarter of a rotation and
pull it out [4-5].
► Undo the spindle nut [4-6] and remove the
flange [4-7] of the saw blade.
► Use the spanner [4-8] as a lever to carefully
push the saw blade out of the tool spin­
dle [4-10].
Use the spanner [4-9] as a lever to carefully
push the cartridge out of the fastening
pins [4-11].
Repeat both steps until the saw blade and
the cartridge have been successfully re­
moved.
8.2 ).
9.6 ).
9.8 ).