Festool TKS 80 EBS Original Instructions Manual page 32

LED status in standby
The green
LED [2-4] lights
up constantly.
The red
LED [2-5] flash­
es slowly.
The green
LED [2-4] lights
up constantly.
The red
LED [2-5] is not
lit.
The green
LED [2-4] flash­
es rapidly.
(alternating)
The red
LED [2-5] flash­
es rapidly.
The green
LED [2-4] lights
up constantly.
The red
LED [2-5] flash­
es rapidly.
The green
LED [2-4] is not
lit.
The red
LED [2-5] flash­
es slowly.
The green
LED [2-4] flash­
es slowly.
The red
LED [2-5] lights
up constantly.
The bench-mounted
circular saw starts up
in approx. 10 sec­
onds.
The bench-mounted
circular saw is ready
to use and is in stand­
by mode.
Restart protection
When activating by­
pass mode, the yel­
low SawStop switch
was released too ear­
ly.
To rectify the
fault, press the red
STOP button.
Contact with the saw
blade in standby.
Remove the
contact trigger and
wait approx. 5 sec­
onds until the fault is
rectified.
Cartridge locking de­
vice fault.
Switch off the
bench-mounted cir­
cular saw and check
the cartridge locking
device.
Saw blade missing or
too small.
Switch off the
bench-mounted cir­
cular saw and insert a
suitable saw blade
(see section 3 ).
The green
LED [2-4] is not
lit.
The red
LED [2-5] lights
up constantly.
LED status during operation
The green
LED [2-4] flash­
es rapidly.
The red
LED [2-5] is not
lit.
The green
LED [2-4] flash­
es slowly.
The red
LED [2-5] is not
lit.
The green
LED [2-4] flash­
es slowly.
The red
LED [2-5] flash­
es rapidly.
LED status in standby or during operation
The green
LED [2-4] is not
lit.
The red
LED [2-5] flash­
es rapidly.
English
Replace the car­
tridge.
Switch off the
bench-mounted cir­
cular saw. If the fault
is still not rectified,
insert a new car­
tridge.
The saw blade comes
to a stop.
The SawStop
technology is active
and is triggered upon
contact.
Activated bypass
mode.
Contact with the saw
blade while bypass
mode is activated
The fault is rectified if
the saw blade comes
to a stop.
Workpiece too damp.
Switch off the
bench-mounted cir­
cular saw and dry the
workpiece or contin­
ue sawing in bypass
mode.
33