Ignition 2bright Par 18 IP User Manual page 45

Setting output power
Rotating the Display
1. Press [ENTER] and then [UP] or [DOWN] repeatedly until the display shows 'Settings' .
Confirm with [ENTER].
2.
Press [UP] or [DOWN] repeatedly until the display shows 'Output Set' . Confirm with
[ENTER].
3.
Use [UP] or [DOWN] to select either 'Standard' (output power 150 W) or 'Full' (output
power 180 W).
4. Press [ENTER] to accept the selection.
1. Press [ENTER] and then [UP] or [DOWN] repeatedly until the display shows 'Settings' .
Confirm with [ENTER].
2.
Press [UP] or [DOWN] repeatedly until the display shows 'Display Rev' . Confirm with
[ENTER].
3.
Use [UP] or [DOWN] to select either 'On' (display rotated by 180 °) or 'Off' (display not
rotated).
4. Press [ENTER] to accept the selection.
Operating
2bright Par 18 IP
45
LED spotlight