Remote Control Of A; Revox Revox; Connecting The Amplifier To The Ac; Supply - Revox B251 Operating Instructions Manual

cable attenuation, these cables should have
a
conductor
cross-section
of
more
than
0.75 mmz.
Caution.
The blackterminals arethe speakergroup and
should not be interconnected. Under no cir-
cumstance maythe
red
terminals
be
connect-
ed
to a different terminal.
1.3
Connecting
the
amplifier
to
the
AG
supply
The
amplifier should be equipped
with
a
pow-
er
supplythat
matches your local
line
voltage.
P
I
ease
verify that the volta
ge specif icati ons on
the rear panel
of
the amplifier conform to your
local
line
voltage. Should this not
be
the case,
the power supply must be replaced
by
your lo-
cal dealer of the country
in
wich the
unit was
sold.
1.2
Special instruction
1.2.1
Remote
control of a
REVOX
tape
recorder through the
REVOX 8251
ampli-
fier
(option)
Tape recorders that are not equipped with
an
infrared receiver can be controlled remotely
through the amplifier from an infrared remote
control
REVOX
8201.ln this case retrofit
kit
No.
78666 must
be installed on the amplifier.
The remote-control cable for the tape trans-
portfunctions
of
the cassette recorder
REVOX
8710 or
the reel-to-reel recorder
REVOX
877
is
to
be
connected
to the socketTAPE TRANS-
PORT
87718710
146l
The amplifier can also be powered on under
control of the timer in the cassette recorder
REVOX
8710.ln this
case the socket POWER
ON B7B0 (on the cassette recorder) and the
socket REMOTE POWER ON
t45l
on the am-
plifier are interconnected with the cable
No.
33209
1.2.2
Acrilic plastic cover
Removal:
-
Hold cover on
its
two
metal strips and
re-
move it by pulling forward.
lnstallation:
-
Hold cover on
its
two metal strips, position
lower edge at an angle below upper group
of controls and snap it
on.
The amplifier
is
controlled
by a microproces-
sor
which initializes
itself when the amplifier
is
connected to the AC supply. lncorrect initiali-
zation manifests itself by leaving the amplifier
in inoperative condition. Should this happen,
briefly disconnect the amplifier from the
AC
supply and reconnect
it.